Slider angle designing tips

1. Normally, all the insertion slopes of the slider are not allowed to be less than 3° to prevent excessive self-locking force and scratched;

2. The angle of the locking surface must be bigger than the angle of the angle pin by 2° or more;

3. For the slider driven by the angle pin, the inclination angle of the slider shall not over 30°;

4. The angle (A) of the angle pin shall not over 22°.

Popular USM Injection Molds

Related News about USM Injection Mold

Design principle of plastic injection mold cooling system
Feb 13, 2022Design principle of cooling system In order to improve the efficiency of the cooling system and make the cavity surface temperature distribution even, the following principles should be followed in...view
Gate position determination of plastic injection mold runner design system
Jan 17, 2022In the selection of gate location, the following issues should be paid attention to: 1. The gate position should be set at the maximum wall thickness of the plastic part, so that the plastic melt...view
Key points of plastic injection mold runner system
Jan 12, 2022The sub-runner is a transitional channel between the main runner and the gate, as the sub-runner is the longgest part of gating system, so it is very important to enhance the parts quality and improve...view