English
русский
USM Blogo Opening
Hello everyone!
Our blog is open today, it is very glad to have the opportunity to meet you here, welcome to visit us whenever you need.
USM is a professional plastic injection mold and molding company that was founded in 2013, it is located in Dongguan city, Guangdong Province, China.
We have been providing service for many different industries, especially for water-assisted and gas-assisted injection mold, overmolding & 2K molding, and pre-deformation mold, we will continue to share more information about the mold.
We are looking forward to contributing to your success!
Welcome to visit our factory and new inquiry.
Popular USM Injection Molds
Related News about USM Injection Mold
Plastic molding shrinkage rate
Dec 30, 2021Plastic parts getting smaller by shrink, due to the temperature decrease during the molding process, and the shrinkage is expressed by the shrinkage rate, it is common plastic shrinkage rates are...view
Banana gate of plastic injection mold runner system design
Feb 7, 2022In order to get the best injection quality, the gate type must be selected carefully, the coommon gate tyeps are: direct gate, side gate, pin-point gate, sub gate,valve gate of hot runner etc. Among...view
The air trapping position in cavity and exhaust method
Mar 2, 2022The air trapping in cavity is usually in the following places: 1. Thin-wall structure cavity, the end of melt flow; 2. The junction of two or more melts; 3. The last area where the melt in the cavity...view
What is the side parting and core pulling mechanisms with their function?
May 31, 2022When there are holes, cavities or cores on the inside or outside of the injection-molded plastic parts that are different from the opening and closing directions of the mold, the plastic parts cannot...view
The common fixing method of angle pin
May 10, 2024The angle pin is a common part of the drive slider, and the fixing and installation methods as following: 1. Pass through the mold plate directly and press the angle pin with the top plate to fix it,...view
Factors affecting the cooling rate of parts by injection molding
Feb 9, 2022It should be shaped by cooling to get stable plastic part after plastic filling the cavity and core side, so most injection molds need to be equipped with cooling devices to make the mold temperature...view