English
русский
Automotive handle mold
Automotive MoldAutomotive Molds Characteristics1. The automotive mold size is very big, and the largest mold weight is nearly 40T;2. The mold structure is complex;3. There are many irregular curved surfaces on the parting surface.More+
Gas & Water Assisted Injection MoldThe differences between water-assisted and gas-assisted molding1. Water-assisted injection molding uses water, and it can be recycled and reused, so the medium water of the two molding processes is cheaper than nitrogen.More+
Insert MoldCommon Manufacturing Methods of Injection-molded Insert ProductsGenerally, there are two methods for making injection molded insert parts:1. Place the insert into the mold before injection molding.More+
Plastic Pipe MoldThe booster pressurizes the nitrogen in the low-pressure storage cylinder into workable high-pressure nitrogen, and stores it in the high-pressure nitrogen cylinder, the maximum pressure of the nitrogen can reach 35MPa in the process.More+
Controling method of plastic injection mold temperatureExcept for heat radiation and heat convection from the mold, most of the heat bring into the mold by the plastic needs to be taken out of the mold by the circulating heat transfer medium by heat condu...More+
Slider designing tips 2The molding parting surface of the slider molding should be made as a shut-off surface as possible, and the width of the shut-off part should be at least 8mm, and do not make a shut-off surface;When u...More+
