English
русский
Automotive handle
Cold Runner MouldCompared with the hot runner mold, a cold runner mold does not require a special heating system for the runner system. It will be cooled with the product together and taken out after injection finishing, and then cut the runner, the cold runner mold is what we often call the traditional mold.More+
Key points of plastic injection mold runner systemThe sub-runner is a transitional channel between the main runner and the gate, as the sub-runner is the longgest part of gating system, so it is very important to enhance the parts quality and improve...More+
64 Cavities Plastic Injection MouldA 64-cavity multi-cavity mold means that 64 pieces of parts can be produced in one injection cycle at the same time, which can improve the production efficiency greatly, save production time and reduce production cost.More+
- HomeEstablished in the year of 1996, HanKing start the business in mould making and injection molding in Longgang, Shenzhen, after years development, we have become a one-stop total plastic solution pr...More+
The sub gate of the plastic injection mold runner systemIn order to get the best injection quality, the gate type must be selected carefully, the coommon gate tyeps are: direct gate, side gate, pin-point gate, sub gate,valve gate of hot runner etc. Among...More+
Limitations of gas-assisted injection molding technologyGas-assisted injection molding technology has obvious advantages in thick wall thicknes and tpipe parts, but this technology still has many limitations, which are mainly reflected in the following asp...More+
